Gorilla Max Strength Clear Construction Adhesive [Waterproof, Non-Foaming]

Please note: Heavy items may require temporary support. Use with mechanical fasteners when hanging large mirrors.

Cartridge

1. Make sure all surfaces are clean and free of dirt, grease and oil. Best if used above 40°F.
2. Unscrew and remove the nozzle from the top of the cartridge and set it aside.
3. Cut the hard plastic tip of the cartridge above the threads, then replace the nozzle.
4. Cut the nozzle at a 45° angle to the desired bead size and insert the cartridge into a caulking gun.
5. Apply adhesive to one surface in a zig-zag pattern or around the inside perimeter of the object, watching for squeeze-out. On rough, uneven surfaces, use enough adhesive to fill gaps.
6. Within 10 minutes, press the surfaces firmly together. The bond is repositionable for 30 minutes.

Tube

1. Make sure all surfaces are clean and free of dirt, grease, oil and old adhesive. Work in a well-ventilated area, ideally above 40°F.
2. Screw on the nozzle and cut it to the desired bead size.
3. Apply in a zig-zag pattern, using enough adhesive to fill gaps on rough, uneven surfaces.
4. Within 30 minutes, press the surfaces together and hold for 30 to 60 seconds.
5. Remove excess adhesive immediately with a dry cloth. Fully cures within 24 hours.

Clean-Up & Storage

1. Wipe off wet adhesive immediately with a dry cloth; isopropyl alcohol or white spirit may be used according to the manufacturer's instructions. Cured adhesive must be scraped or removed mechanically.
2. Store in a cool, dry place with the nozzle attached and filled with adhesive to seal the container. To reuse, remove the nozzle and clear the cured adhesive from the tip.
3. Do not freeze. Keep away from children and animals.

Technical Information